EZ-ACCESS PATHWA MODULAR ACCESS SYSTEM - Manual (Page 46)

- 46 -
6.10. GATE: The MUG36 (MODULAR GATE 36”) can be installed to swing either direction.
Determine which side the hinge should be on and the direction the gate should swing
before (FIG. 6.26).
FIG. 6.26
6.10.1. Using the rubber mallet, tap in the provided round tube plugs into the tubing
ends on the gate. (FIG. 6.27).
FIG. 6.27
6.10.2. Position the gate hinge against the vertical handrail post. Position the hinge
vertically so the top of the gate is even with the top of the handrail and so
that the edge of the hinge is flush with the edge of the vertical handrail post.
Mark holes with pencil using the holes in the hinge as a template then drill
three 5/16
″ holes through both sides of the vertical handrail tube (FIG. 6.28).
Install fasteners through hinge and vertical handrail tube and secure as
shown (FIG. 6.29).
FIG. 6.28 FIG 6.29
IMPORTANT:
INSTALL BOLT FROM
THIS SIDE
1- 1/2″ DIAMETER TUBE PLUG
DRILL 1/8″ HOLES
1/4″ NUT
1/4″ WASHER
1/4″ X 2″ LONG HEX BOLT