Save these instructions – Dimplex DF3215NH User Manual

Page 5

Advertising
background image

5

manual. Any other use not recommended by the manufacturer may cause

fire, electric shock or injury to persons.

14. Avoid the use of an extension cord. Extension cords may overheat and

cause a risk of fire. If you must use an extension cord, the cord must be

No. 14 AWG minimum size and rated no less than 1875 Watts.

15. Do not burn wood or other materials in the electric fireplace.
16. Do not strike the fireplace glass.
17. Always use a certified electrician should new circuits or outlets be required.
18. Always use properly grounded, fused and polarized outlets.
19. Disconnect all power supply before performing any cleaning, maintenance

or relocation of the unit.

20. When transporting or storing the unit and cord, keep in a dry place, free

from excessive vibration and store so as to avoid damage.

CAUTION

RISK OF ELEcTRIc ShOcK

DO NOT OPEN

NO USER-SERvIcEABLE PARTS INSIDE

SAVE THESE INSTRUCTIONS

!

NOTE: Procedures and techniques that are considered important enough

to emphasize.

CAUTION: Procedures and techniques which, if not carefully followed, will

result in damage to the equipment.

WARNING: Procedures and techniques which, if not carefully followed, will

expose the user to the risk of fire, serious injury, illness or death.

!

NOTE: This equipment has been tested and found to comply with the

limits for class B digital device, pursuant to part 15 of the Fcc Rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio

or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and the receiver.
· connect the equipment into an outlet on a circuit different from that to

Advertising