Dimplex DF3215NH - Manual (Page 7)

7
! NOTE: A 15 Amp, 120 volt circuit is required. A dedicated circuit
is preferred but not essential in all cases. A dedicated circuit will
be required if, after installation, the circuit breaker trips or fuse
blows on a regular basis when the heater is operating. Additional
appliances on the same circuit may exceed the current rating of the
circuit breaker.
WARNING: Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk
of fire, electric shock and injury to persons. Do not attempt to wire
your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.
Site Selection And Preparation
This section provides instructions for selecting a location and preparing
the site to install the fireplace into your Dimplex mantel surround.
1. Select a suitable location that is not susceptible to moisture and is
away from drapes, furniture and high traffic.
2. For ease of electrical hook up you may wish to locate the fireplace
near an existing outlet (refer to NOTE 1).
3. Store the fireplace in a safe dry and dust free location.
! NOTE: The dimensions of the fireplace are 36 ½ inches (927 mm)
wide X 31 ¾ inches (806 mm) high X 13 inches (330 mm) deep.
The viewing area is 32 inches (813 mm) wide and 28 ¼ (715 mm)
high. The fireplace does not require any additional venting .
Fireplace Installation
1. Install the Bi-fold doors to the fireplace.
! IMPORTANT: Bi-fold doors MUST be installed to the firebox prior
to installing firebox to mantel.