Hatteland Display 20 inch - HM 20T07 MIL-H - Manual (Page 23)

23 Operation
IND100064-27
USER CONTROLS:
The On Screen Display (OSD menu) controls are located under the metal hatch on the left side of the unit. To loosen it, use a
suitable screwdriver and dismount the two screws as illustrated in FIG 1.
1: Press the “MENU” button. The OSD menu will show all the available functions you can adjust or control.
2: You can move to the next icon by pressing “MENU”.
3: Select options within icon menu by pressing “UP” or “DOWN” buttons. The selected option will turn yellow.
4: Use “+” or “-” buttons to increase/decrease values.
5: Move the selection left or right by using “+” or “-” buttons. The selected option will turn green.
6: To confirm the selection, press “+” button. To abort press “-” button.
OSD MENU:
T he On Screen Display (OSD menu) contains several functions that will let the user to adjust or setup the display to their preferred
setting. The functions are shown as easy understandable icons. Some of the menus have sub-menus, use “+” to access and
“MENU” to go back to the previous menu. The OSD menu consists of 4 modes: (Icon beside function indicates if it’s available in
that mode)
Mode 1 - Available functions in RGB / DVI* MODE Simplified OSD Menu - (company logo will appear)
User can adjust the most common functions needed to operate the display.
*Some functions are not available in DVI mode.
Mode 2 - Available functions in RGB / DVI* MODE Advanced OSD Menu - (no company logo will appear)
User can access more advanced functions. (Service menu).
*Some functions are not available in DVI mode.
Mode 3 - Available functions in VIDEO MODE Simplified OSD Menu - (company logo will appear)
User can adjust the most common functions needed to operate the display.
Mode 4 - Available functions in VIDEO MODE Advanced OSD Menu - (no company logo will appear)
User can access more advanced functions. (Service menu).
*RGB/DVI MODE = When RGB/DVI signal (i.e OS or radar / charts) are displayed full screen.
*VIDEO MODE = When video signal (i.e CAMERA / VCR / DVD) are displayed full screen.
Advanced/Service Menu:
You will have a full set of functions available for your personal perference. Only for experienced users. To access the “Advanced/
Full” OSD Menu, you must press and hold the “DOWN” button while turning power on. When picture appears, release the “DOWN”
button and press “MENU” to access
Simplified/User Menu:
You will have a limited set of functions available for your personal perference. For the common user.
Memorized State Menu: (Also referenced as “Normal/Toggle”)
The menu will either be advanced or simplified upon startup of display. If user changes from simplified to advanced menu or visa
versa, then this will be memorized in memory and it stays in that mode until user changes it back again.
WARNING !! ONLY A QUALIFIED SERVICE ENGINEER SHOULD ACCESS THE ADVANCED/SERVICE MENU.
PERFORMANCE OF THE DISPLAY MAY BE SERIOUSLY AFFECTED!
Operation
1
2
3
4
FIG 1
MENU Access Button
Adjust Buttons -/+
UP/Down Buttons