HITEC DPC-10 - Manual (Page 12)

12
Hitec Brushless Servo PC Programming Interface
DPC-10
DPC-10 Software Operating Manual
Fail Safe Position
Note: Remember to “Write All” your settings to your
servo before closing the DPC-10 software and dis-
connecting your servo. Failure to do so will result in
the loss of your programmed settings.
Section 5
Saving and Loading Files/
Restoring Default Files With the DPC-10 software you have the ability to
save and load servo parameter files. This is helpful
when needing to set up multiple servos with the
same parameters. The DPC-10 software also has
the ability to restore the factory defaults file in the
event the user setup doesn’t operate correctly. The
following details how to use these features.
Saving Files Once you have completed your servo setup and
written the setup to the servo, click on “Read Servo.”
Next click on “SAVE” to open the save file dialog box.
Navigate to the location that you want to save your
file to, enter a name for your servo and click “Save.”
You have successfully saved your servo parameters
to a file.
To load a parameter file click on “OPEN”, navigate
to the location where you stored your file and click
“Open.” You will get the “File load has completed”
prompt. Click “OK.” Now click “Write All” to load the
setting onto the servo. Once you get the “Write All
Loading Files