Dpc-10 – HITEC DPC-10 User Manual
Page 7
7
Hitec Brushless Servo PC Programming Interface
DPC-10
DPC-10 Software Operating Manual
1. Direction of Rotation
2. Travel Speed (Slower)
3. Dead Band Width
4. Soft Start Percentage
5. Center and End Points
6. FAIL SAFE, On or Off
Note: To make your changes permanent you must
“write” the programming to the servo by clicking
the “WRITE ALL” button. You can do this after each
programming step or wait until you have finished all
programming.
Direction of Rotation
Normal servo rotation based on 900 - 2100µs input
signal is clockwise from left to right. You can change
this to counterclockwise by clicking on the Direction
of travel button as shown. The direction is shown as
CW for clockwise and CCW for counterclockwise.
Travel Speed
This feature is useful for users who do not have
servo speed control functions on their transmitter.
Reducing the travel speed is a nice feature to slow
down aircraft landing gear retracts. The servo speed
Programming Hitec Brushless Servos