HITEC DPC-10 - Manual (Page 8)

8
Hitec Brushless Servo PC Programming Interface
DPC-10
DPC-10 Software Operating Manual
Some applications, such as using multiple servos on
a single control surface, may require you to change
the center “Dead Band” to prevent the servos from
fighting each other. Users can adjust the center
point “Dead Band Width” to one of five choices with 1
being the most sensitive and 5 the least sensitive.
Dead Band Width
Soft Start Setting
The soft start setting allows users to set how fast the
servos react when first powered on. Using a slower
soft start setting can prevent damage to your model
by slowly moving the servo into position. Default
setting is 20% (slowest). There are five settings from
20% to 100% which is an instantaneous reaction.
Note: This setting has no affect on the reaction
speed of the servo once it is powered up.
Center and End Point
Adjustment Setting (EPA)
With the EPA setup, users can customize the center
point and left/right servo travel end points. This can
be helpful to fine tune your model’s control surfaces.
To set the Center and Endpoints, click on the
“Setting” box under the EPA programming section.
Travel Speed function will only slow a servo down. You cannot make
a servo travel faster than its rated speed. You can
adjust the servo’s travel speed in ten proportional
steps from a minimum speed (10%) up to its
maximum speed (100%).