HITEC DPC-10 - Manual (Page 9)

9
Hitec Brushless Servo PC Programming Interface
DPC-10
DPC-10 Software Operating Manual
Center and End Point
Adjustment Setting (EPA)
The first setting is the center point. If you don’t want
to change the center point, click “skip” otherwise
you can adjust the center point using three different
methods.
1. Click on and move the slide in the adjustment bar
to move in larger steps.
2. Click the arrows “< >” on each end to make the
smallest adjustments.
3. Click on the white space of the adjustment bar to
move it in 10 point increments.
When you have reached your desired center point,
press “OK” to continue. Now you will set up the left
and right end points. Click “OK” when prompted by
the pop-up screens. The left and right end points are
adjusted in same manner as the center points with
the exception that clicking on the white space of the
adjustment bar results in movements of 10 point
increments and clicking the < and > arrows move in
increments of 0.5%. Once you have set your left end
points click “OK” to set the right end points then click
“OK” again to complete the EPA setup process.
NOTE: The numbers represented in
the EPA adjustments are shown as
percentages. With center at 0 and left
and right endpoints at 100%, the servo
will move approximately 100 degrees in
each direction. It should also be noted
that the left and right adjustment values
will change if the center point is adjusted.