Konig Electronic WLAN router 300 Mbps - Manual (Page 35)

35
This device can record 3 sets. When the host (must be admin) logs in to the web management, the
device will record MAC address of this host. Before this host configures the Internet Access Control, we
suggest the end-user to enable this feature first.
MAC Address Control allows you to assign different access rights for different users and to assign a
specific IP address to a certain MAC address.
MAC Address Control
Check “Enable” to enable the “MAC Address Control”. All of the settings
in this page will take effect only when “Enable” is checked.
Connection control Check “Connection control” to enable the controlling of which wired and
wireless clients can connect to this device. If a client is denied to connect
to this device, it means the client cannot access the Internet either.
Choose “allow” or “deny” to allow or deny the clients, whose MAC
addresses are not in the “control table” (please see below), to connect to
this device.
Association control Check “Association control” to enable the controlling of which wireless
client can associate to the wireless LAN. If a client is denied to associate
to the wireless LAN, it means the client cannot send or receive any data
via this device. Choose “allow” or “deny” to allow or deny the clients,
whose MAC addresses are not in the “control table”, to associate to the
wireless LAN.
Control table
“Control table” is the table at the bottom of the “MAC Address Control” page. Each row of this table
indicates the MAC address and the expected IP address mapping of a client. There are four columns in
this table: