Konig Electronic WLAN router 300 Mbps - Manual (Page 41)

41
1. QoS: Quality of Service.
2. Local IP/Ports: The IP and ports that LAN side PC uses. The value 0 is not used.
3. Remote IP : Ports: The IP and ports that remote server uses. The value 0 is not used.
For example, if you want to guarantee the HTTP bandwidth, you could keep Local IP/Port as 0/0 and
Remote IP/Port as 0/80.
SNMP
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to give a user the
capability to remotely manage a computer network by polling and setting terminal values and
monitoring network events.
Enable SNMP
You must check Local or Remote or both to enable SNMP function. If Local is checked, this device will
respond to requests from LAN. If Remote is checked, this device will respond to requests from WAN.
Get Community
Setting the community of Get Request that your device will respond to.
Set Community
Setting the community of Set Request your device will accept.
IP 1, IP 2, IP 3, IP 4
Input your SNMP Management PC’s IP here. The user has to configure this device so it knows where to
send the SNMP trap message.
SNMP Version
Please select the correct SNMP version that your SNMP management software supports.
WAN Access IP Address
If the user wants to limit access to specific IP address , please input the item. The default is 0.0.0.0 and
means every IP of the Internet can get some information of the device with SNMP protocol.
Click on “Save” to store your setting or “Undo” to cancel.