Konig Electronic WLAN router 300 Mbps - Manual (Page 42)

42
Routing
Routing Table allows you to determine which physical interface address to use for outgoing IP data
grams. If you have more than one router and subnet, you will need to enable the routing table to allow
packets to find the proper routing path and allow different subnets to communicate with each other.
Routing table settings are settings used to set up the functions of static routing.
Dynamic Routing
Routing Information Protocol (RIP) will exchange information about destinations for computing routes
throughout the network. Please select RIPv2 only if you have different subnets in your network.
Otherwise, please select RIPv1 if you need this protocol.
Static Routing: For static routing, you can specify up to 8 routing rules. You can enter the destination
IP Address, Subnet Mask, Gateway, Hop for each routing rule, and then enable or disable the rule by
checking or unchecking the Enable check box.
Example: