Konig Electronic WLAN router 300 Mbps - Manual (Page 36)

36
MAC Address The MAC address indicates a specific client.
IP Address Expected IP address of the corresponding client. Leave it blank if you are
not interested in the IP address.
C When “Connection control” is selected, select “C” to allow the
corresponding client to connect to this device.
A When “Association control” is selected, select “A” to allow the
corresponding client to associate to the wireless LAN.
In this page, we provide the following combo box and button to help you to input the MAC address.
You can select a specific client in the “DHCP clients” combo box, and then click on the “Copy to” button
to copy the MAC address of the client you select to the ID selected in the “ID” combo box.
Previous page and Next
Page
To make this setup page simple and clear, we have divided the “control
table” into several pages. You can use these buttons to navigate to
different pages.
Example:
In this scenario, there are three clients listed in the control table. Clients 1 and 2 are wireless, and client
3 is wired.
1. The “MAC Address Control” function is enabled.
2. “Connection control” is enabled, and all of the wired and wireless clients not listed in the “control
table” are “allowed” to connect to this device.
3. “Association control” is enabled, and all of the wireless clients not listed in the “control table” are
“denied” to associate to the wireless LAN.
4. Clients 1 and 3 have fixed IP addresses either from the DHCP server of this device or are manually
assigned:
ID 1 – “00-12-34-56-78-90” --> 192.168.12.100
ID 3 – “00-98-76-54-32-10” --> 192.168.12.101
Client 2 will obtain its IP address from the IP address pool specified in the "DHCP Server" page or it
can use a manually assigned static IP address.