LG Motorsports LG G5 Coil Overs - Manual (Page 17)

Figure 35: Lower shock bolt
Once the four upper bolts are secure, pull the lower control arm into place and install the
spindle bolt and shock bolts. Install the nuts and tighten securely.
ADVANCED INSTALL:
For those using a shop with a four wheel scale pad, first start out by getting the ride
height close to where you would like it. Once this is done, please setup the alignment of
the car to what you would like it to be, and set all tires to equal pressures (typically
34psi). Disconnect one side of the sway bars, both one front and one rear. Once this is
done, make sure the car is settled and roll it onto the scale pads by the tires, not pushing
down on the body of the car. Be sure that the scales are zeroed before placing the car on
the pads. Once the car is on the pads, have the driver, or someone of similar size and
weight inside the car and fuel as close to empty as possible. Take a look at the corner
weights of the car, and look at the cross from LF to RR. You want this percentage to be
as close to 50-50 as possible. Most scale pads will have a layout similar to as shown in
figure 36. Turn of the RF and LR to get the cross weights, it will give you a weight for
that side as well as a percentage.