LG Motorsports Track Box for C6, Old Design - Manual (Page 6)

6. Locate the “tan” and “tan/black stripe” wires from this connector. Important: There are multiple
tan wires in this connector. Make sure that you locate the two wires in location 19 and 20, shown
in Figure 6.
Figure 6
7. Once you have identified these four wires, they must be cut so that the TPMS controller can be
installed. Leave yourself a few inches to work with.
8. Cut the included shrink tubing into 6 equal lenth pieces, each about 1 inch in length. Strip about ½
inch of insulation from the end of each wire and slide a piece of the included shrink tubing over each
end.
9. Wires 1 and 2 and wires 3 and 4 on the TrackBox harness are twisted together. Do NOT un-twist
them. Connect the TrackBox harness into the vehicle harness as follows:

Pin 1, Blue - wrap the two tan wires from the BCM connector together and solder together

Pin 2, Yellow/Red - wrap the two tan / black wires from the BCM connector together and
solder together

Pin 3, Blue - wrap the two tan wires from the vehicle body harness together and solder
together

Pin 4, Yellow/Red - wrap the two tan / black wires from the vehicle body harness together
and solder together

Pin 5, Black – solder to vehicle ground. There is a convenient ground located under the kick
panel near the BCM, shown in Figure 8.

Pin 6, Purple - 12V battery source. This wire must have power even when the vehicle
ignition is “off”. A convenient power source is located right at the BCM, shown in Figure 7.