LG Motorsports Track Box for C6, Old Design - Manual (Page 7)

10. Slide the shrink tubing over the solder joint and apply heat via a heat gun to the shrink tubing to
shrink it tightly against the wiring.
11. If you removed the OEM mode connector from the TrackBox harness, reinsert it now.
12. Reconnect the negative battery terminal on the vehicle.
Note: Whenever the TrackBox is not installed this connector should be inserted. Do not discard
this connector!
13. To verify that your wiring is correct, simply start the car. It should start and function as normal with
no error messages present (unless there were any pre-existing conditions causing a warning lamp),
as shown in Figure 9.
Figure 7
Figure 7 Figure 8