Lumagen VisionPro - Manual (Page 25)

Vision Pro
™ User Manual and Installer Guide
© 2003 Lumagen, Inc. 22 Rev 1.13
Menu Timeout
The time the MENU is displayed after the last action can be changes from normal to long
with the following command:
MENU 0 9 0 5
Toggle menu timeout. Short (default) or long. (can
be saved)
Power Indication
By default the front panel LCD light is illuminated for a short time after a command. This
behavior can be changed so that the LCD light is on while the unit is on. The command
is:
MENU 0 9 2 5
Toggle light as "activity" (default) or "power."
Zoom Step
A smaller zoom step of about 5% can be selected instead of the normal step of about
15%. The command format is:
MENU 0 9 2 3
Toggle zoom-step between default and 5%.
Sidebar Pan
To help prevent screen burnin with 4:3 sources on widescreen displays, the output can be
slowly moved left and right a fractional pixel step every few minutes. While not easily
visible to the viewer, this will help minimize the visibility of screen burn-in. The
command is:
MENU 0 9 8 7
Toggle Sidebar-pan for antiburn. Default = off.
Auxiliary Control
The auxiliary control connector can be used to turn the
VisionPro on ( PWRON ) when the
input is asserted to a TTL high level, or it can be asserted as an output to turn an external
device on (
SWTCHOUT
) when the
VisionPro power is on. The AUX
connector always uses
TTL signal levels. The command format is:
MENU → MISC → POWR → AUX →
( OFF , PWRON , SWTCHOUT) , OK