Mighty Mule MM600ET-PRO - Manual (Page 41)

38
If you have a question about any special order item,
just call 1-800-543-GATE!
Accessories are Available From Your Retail Store (con't)
The contents of all material available on this installation manual are copyrighted by Gates That Open, LLC (“GTO”), unless otherwise indicated. All rights are reserved by GTO, and
content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except with the prior, written permission of GTO. Any reprinting of
GTO publications is by permission only. Copyright infringement is a violation of federal law.
Mighty Mule¨, E-Z Gate¨, GTO¨, are registered trademarks of Gates That Open, LLC, America’s DIY Automatic Gate Openers is a trademark of Gates That Open, LLC and are the
exclusive property of Gates That Open, LLC (“GTO”).
All rights are reserved by GTO, and these marks may not be used, in any for without the prior, written permission of GTO.
Push to Open Bracket (FM148)
Required when Mighty Mule 600 gate operator(s) must push the gate open, such as on a sloping driveway or where
space prevents gate(s) from opening inward (pulled open).
Column Mount Lock Receiver (433IH)
For mounting the Automatic Gate Lock on brick columns, walls, or for other applications with limited space
between gate and post.
Replacement Transformer (RB570)
Standard 18 volt, 2200 mA, AC transformer for maintaining the battery included with the Mighty Mule® gate
operator. This is the only transformer approved for use with UL325 Mighty Mule® gate operator systems.
Garage Door Receiver (RB709U)
The Garage Door Receiver allows you to use the same Mighty Mule® entry transmitter to operate your gate operator
and your garage door operator. Compatible with most garage door operators.
Wireless Entry Intercom / Keypad (FM136)
Allows owner to screen guest at the gate before allowing access to the property. Keypad also allows owner
to give up to 25 programmable entry codes to family, friends or approved delivery personnel. Codes can be
permanent of temporary. Up to 500 feet reception.
Additional base stations available (F3101MBC).
Low Voltage Wire (RB509)
The 16 gauge, multi-stranded, dual conductor Low Voltage Wire is for connecting the AC powered
transformer, or the Solar Panel to the control board. Also used for the connection of accessories, such as locks,
keypads, push buttons and other wired control devices. This specially designed wire is UV treated, PVC coated
and ready for direct burial. Available in 1000' rolls or special lengths.
POW ER Key pad
Bat t Lo w Gran t Perm issio n
An sw er
DV 9V ACC ES S CONT ROL SYS TE MS
1- 80 0-5 43 -4 28 3