MOCET IP3021A User Manual
Page 13
Page 13
MOCET IP3022 SOHO IP Deskphone User Guide
1.3.4. Connect the Handset to the Phone
After unpacking the box, connect the handset to the curly handset cord and then connect
the other end of the curly handset cord to the port marked HAND with the handset icon
on the bottom of the phone.
1.3.5. Connect the Ethernet Cables
Using a general CAT-5 Ethernet cable, follow the installation steps below:
If your Ethernet switch supports PoE:
Please connect an Ethernet cable to the switch port from the LAN port
of the
phone. Then you will see the phone LEDs and buttons light up momentarily and the
phone will boot.
If your Ethernet switch does not support PoE:
(1) Please connect an Ethernet cable to the switch port from the LAN port
of the
phone.
(2) Plug in the phone power adaptor* to the wall power outlet then plug the barrel plug
to the power port
on the back of the phone. You should see the phone LEDs and
buttons light up momentarily and the phone will boot.
To eliminate the requirement for multiple Ethernet cables to an user’s location, the user’s
computer can be connected to the network through the second Ethernet port
on the
phone.
Do not use other power adapters. Use only the MOCET IP3022 Power
Adapter with your IP3022 IP Phone. Adapters for other devices may
damage IP3022 IP Phone.
B
30°
CAUTION