MOCET IP3021A - Manual (Page 46)

Page 46
MOCET IP3022 SOHO IP Deskphone User Guide
3.3. Configuring Your IP Phone for Service
The phone must be configured for the hosted SIP service or IP PBX before operation. The
phone is usually pre-configured by the administrator or hosted SIP service provider. For an
advanced or experienced user, you may refer to the IP3022 Administrator Guide for full
information on how to configure all the settings of the IP3022 IP phone.
3.4. Line Selection
The phone can support up to 3 SIP lines. To select a line you can:
1. Use the preferred line setting. That means when you pick up handset, or press the
speakerphone key, or press headset key when not on a call, the phone will
automatically use the preferred line for the call.
2. If the preferred line is not the line you want to use, you can press Line Key buttons
( ) on the right hand side of the LCD to switch to the desired line. Press the Line
Key buttons ( ), which will connect to the chosen line.
3.5. Placing a Call
You can place a call in many ways from the phone:
 Using the handset
 Using the speakerphone
 Using the headset
 Pressing a line key
You can also dial the number first and then choose the method you will use to dial the
other party. This is called pre-dialing. During a call, you can alternate between using the
handset, headset or speakerphone modes by pressing the speakerphone key( ), the
headset key( ) or picking up the handset while on a speakerphone call. The call
duration on an active call is shown on the LCD during the call. To place a new call: