PermaGreen Triumph Spreader Sprayer - Manual (Page 41)

Service Manual 37
Spinner Shaft coupler
Loosen Bolts
Brake adjustment (Refer to FIGURE 25)
To increase braking, loosen jam nut and extend Turnbuckle Ad-
juster. Test braking and adjust as necessary. Tighten jam nut.
To decrease braking, loosen jam nut and retract Turnbuckle Ad-
juster. Test braking and adjust as necessary. Tighten jam nut.
After adjusting, Conduct the Safety Device Test 3, Brake Systems,
(page 18) in the “Driver’s Training and Operation” section of this
Manual.
Read Safety Manual WARNING 5, Safety Devices before
starting or operating the Triumph.
Adjusting Pressure in Fluid-filled Tires
On a level open area free from obstructions and bystanders, lock
both Brakes, shift into Neutral, and start engine.
Tires are filled with pressurized diluted RV antifreeze to provide
ballast for a lower center of gravity. Explosive separation of rim
and tires may cause serious injury.
•
DO NOT remove fluid from tires.
• All replacement tires must be fluid filled.
•
Wear a face shield when checking, filling, and repairing fluid-
filled tires.
•
Refer to the Service Manual for instructions on repairing fluid
filled tires.
•
Do not attempt to check, repair or replace fluid fill tires without
the proper equipment.
• Use a clip-on chuck and extension hose. Stand to the side of
the tire when filling.
• Always maintain tire pressure at 12 PSI. Do not under or over
inflate tires.
• Rear tires have split rims. Release tire pressure prior to loosen-
ing any nuts or bolts.
•
Never weld or heat the tire rims as this could cause a tire explo-
sion or structural damage to the rim.
•
Check tires often for cuts, wear, bubbles and missing or lose
lug nuts. Check pressure often.
•
Fix or replace worn or damaged tires, rims, and hardware.
Read Safety Manual WARNING 18, Tire Safety before start-
ing, operating or performing repairs or maintenance on the
Triumph.
Fluid-filled tires are Safety Devices. Keep pressure at 12 PSI
( 83 Kilopascals). DO NOT operate machine without Fluid-
filled tires. Replace any lost fluid.
Lubrication
Lubricate (2) Rear wheel bearings (A)
Lubricate (2) Articulating joint rod ends (B)
Lubricate (2) Transaxle bearings (A)
Lubricate (2) Front wheel hubs (B)
Pic
B
A
B
A B
FIGURE 23, Grease points
FIGURE 24, Grease points
FIGURE 25, Adjusting brakes