Dolby Laboratories P/N 91659 - Manual (Page 11)

DolbyRemote Installation and Operation
2-1
Chapter 2
Establishing Communication
2.1 Starting DolbyRemote
From the Windows Start button, select DolbyRemote from the folder in which you
installed the DolbyRemote application. The Open Device window is displayed,
Figure 2-1.
Figure 2-1 DolbyRemote Open Device Window
2.1.1 Device Type
Selects the Dolby encoder model to be controlled. Choices are DP561, DP567 or DP569.
2.1.2 Communications
These settings control the communication parameters for the DolbyRemote application.
The corresponding parameters must be set for the appropriate PC communications port.
Port
Select the computer communications port to be used. DolbyRemote allows COM1
through COM10. The correct port will depend on the computer configuration.
Baud Rate
The communication baud rate for the DP567 and DP569 may be set to 9,600, 19,200
or 38,400. The default rate for all encoders is 38,400. The baud rate is configurable