Dolby Laboratories P/N 91659 - Manual (Page 12)

DolbyRemote Installation and Operation Establishing Communication
2-2
through the front panel of the encoder. The rate you select in DolbyRemote must
match the rate selected in the unit.
Address
The default address setting for the DP567 and DP569 is 0x8280. If the address has
been changed from the front panel of the encoder, set the remote address accordingly.
If DP561 is selected as the Device Type, only the Port parameter may be set; Baud
and Address are fixed at 38,400 and 9080, respectively
.
2.1.3 Off-Line
The DolbyRemote application may be used off line, without the presence of an
encoder. This allows configurations to be preprogrammed and stored. Off-line mode
is selected by checking the Off Line box when opening a unit.
Figure 2-2 Device Off Line
Once the desired parameters have been set, as described above, click OK. The
DolbyRemote Window is displayed. When the DolbyRemote application establishes
communication with the unit, it will display the unit's current settings.