Southbend NODR14: Floor Model Rinse Station - Manual (Page 7)

NOD14: Floor Model High Efficiency Gas Pasta Cooker
INSTALLATION
L20-393, rev.1 (08/14) 3
WARNING
DO NOT install legs or casters, or perform leveling procedure when
appliance is in operation or full of hot liquids. Serious injury could result.
WARNING
This appliance must be installed with the legs or casters provided by the manufacturer.
1.3. LEG/CASTER INSTALLATION AND LEVELING
When you receive your appliance it is completely assembled with the possible exception of the legs (or casters). This
appliance must be installed with legs or casters; it cannot be curb mounted. Curb mounting will seriously inhibit this
appliance’s ability to effect proper component ventilation. The legs/casters must be installed before connecting the
appliance to the gas supply. The legs provide the necessary height to meet sanitation requirements and assure
adequate air supply to the combustion system. Use the following procedure
Required tools: 7/16 “ wrench and socket and a large pair of water pump pliers.
1. Remove all loose accessories and carefully place the appliance on its back to avoid damage to the cabinet and
splash back. Protect the outside of the appliance with cardboard or a drop cloth when laying it down. Take care
not to pinch any electrical cords between the cabinet and the floor.
2. Attach each leg/caster with the hex head screws and nuts supplied. Each leg/caster requires four 1/4-20 x 5/8”
hex head screws and nuts. Insure that all screws are tight.
3. Mount the screws from the inside of the appliance with the nut on the outside (bottom, see diagram below) of the
appliance. The nuts have lock washers attached to them, therefore it is not necessary to use separate lock
washers.
4. When all four legs/casters are securely mounted, stand the unit upright, being careful not to put too much weight
on any one leg or caster. Adjust the height and level the appliance by adjusting the leveling devices (B) with
water pump pliers. Rotating the leveling device in a Clockwise (CW) direction will reduce the height of the
appliance, Counter Clockwise rotation will increase the height of the appliance. For casters, loosen 2 set screws
(A) before leveling, adjust the height, then retighten.