Speck Electronics LiLo - Manual (Page 19)

Chapter 3 Operation Section 15
The Lilo has separate line amp modules for each input as well as
separate trim controls. This switch selects the Line-A or
Line-B line amp module. Two yellow LED's display the
status of the switch.
This control provides up to 12dB of gain for the Line-A
input. The factory setting is fully counter-clockwise (0 dB).
A small flat blade screwdriver can be used to adjust this pot.
This control provides up to 12dB of gain for the Line-B
input.
Each input channel on the LiLo has a balanced send and return
available via separate ¼” TRS jacks on the rear connector panel.
The insert signal path is immediately after the Polarity switch and
just before the fader. When this insert switch is depressed, any
audio device connected to the insert connectors is inserted in the
channel's audio path. If the insert switch is pushed in and nothing is
plugged into the send/return jacks, the signal will pass through the
channel since the jacks have switching (normaling) contacts that are
only broken by the insertion of a plug. A green LED on this switch
illuminates indicating that the insert is enabled.
This switch reverses the polarity of the Line-A and Line-B input
signal by 180 degrees.
This 100mm slider adjusts the level for the input channel.
The operation of the slide fader will control the level to the
stereo mix, aux sends, group assigns, and the direct output.
A good starting position for this slide fader is to align the
slider knob to the #10 mark on the panel.
Depressing this switch allows you to isolate any input
channel to the monitor outputs while maintaining stereo
perspective.
Any combination of input channels, group assign, or aux
returns may be soloed without interrupting the flow of the
signal to the main mix feed. A red LED on this switch as well as
the master Solo indicator will illuminate if a channel is soloed.
Depressing this button eliminates all signal flow to the channels
left/right mix, group assigns, as well as the aux sends.
This center detent pan control places the channel anywhere in the
stereo left/right mix when the Mix Assign is enabled.
1. Line Input Select
3
2. Line-A Gain Trim
3. Line-B Gain
4. Insert Select
5. Polarity
Input Channel
6. Slide Fader
7. Solo
8. Mute Switch
9. Pan Control
2
1
5
4
7
8
6
9