Speck Electronics LiLo - Manual (Page 6)

Chapter 1 Introduction Section 2
The LiLo is supplied with the following list of accessories:
- External regulated power supply:
Model PS5-3 for LiLo-16
Model PS5-5 for LiLo-24
- DC Power supply cable (10 foot, 7 conductor)
- AC Power cord (NA version only)
- Operations Manual
This product and its power supply are intended to operate from a single phase
AC power source that does not apply more than 240 Volts RMS between the
supply conductors or between either supply conductor and ground.
The external power supply for the LiLo is grounded through the “earth”
conductor of the power cord. To avoid electrical shock, plug the power cord
into a properly wired receptacle before making any connection from the
power supply to the mixer. A protective ground connection, by the way of the
grounding conductor in the power cord, is essential for safe operation.
The three conductor line cord and plug assembly is wired in accordance with
NEMA convention (line - black, Neutral - white, and safety earth - green).
When using the LiLo and its power supply outside North America, it may be
necessary to adapt a different power cord for that specific country.
To avoid a fire hazard, use only a fuse of the correct type, voltage rating and
current rating as specified in this manual. See Figure 7 on Page 10 for fuse
chart.
To avoid personal injury, do not remove the top cover from the power supply,
and never operate the external power supply without the cover properly
installed. If it becomes necessary to service any part of the mixer, always
unplug the AC power and disconnect the DC interface cable before
proceeding.
Short for “Line-in/Line-out”, the LiLo is a high-definition desktop analog line
mixer for routing and blending your external gear. With more than 100
balanced input/output connections, this modular console will mix over 36
signals with unmatched signal routing, generous amounts of headroom, and a
neutral signal path. The LiLo is targeted at recording studios, project studios,
and audio post-production installations.
Operator Safety
Summary
LiLo General
Description
Standard Accessories
Upon loss of the protective ground connection, all accessible
conductive parts, including knobs and controls that may
appear to be insulating, can render an electric shock.