Speck Electronics LiLo - Manual (Page 21)

Chapter 3 Operation Section 17
Aux Sends
Each input channel has four aux sends that can be switched pre or
post the faders. The Pre/Post functions can be configured to
accommodate different mixing applications.
Adjusts the level to the Aux busses 1 and 2.
This switch selects the source of Aux Sends 1 & 2. In the “Post á”
position, the aux sends reflect any adjustment to the fader or mute.
In the “Pre â” position, the channels fader has no effect on the
level set at the Aux sends.
When the “AFP” switch is pushed, the pan control allows
the signal to be panned across the 1 and 2 Aux Sends. The
"AFP" function is described on page 16.
Adjusts the level to the Aux busses 3 and 4.
This switch selects the source of Aux Sends 3 & 4. In the
“Post á” position, the Aux Sends reflect any adjustment to
the fader or mute. In the “Pre â” position, the channels
fader has no effect on the level set at the Aux Sends.
The source of the “Pre” switch position for Aux Sends 3-4
can be pre-fader (default) or pre-insert using a push-jumper
as shown in Figure 9a on page 19.
This function is similar to the Group Select in that it selects the
source for the Aux Sends 3 and 4. In the up position, the source for
the send is the channels fader. When depressed to the Line-B
position, the source for Aux Sends 3 & 4 is “exclusively” the
channels Line-B line amp.
Aux 2 can be
configured to send a signal to the direct output. (See jumper
configuration Figure 9b on Page 19)
Aux 4 can be
configured to send a signal to the direct output. (See jumper
configuration Figure 9b on Page 19)
20. Aux 3&4
Source Select
16. Aux Sends 1&2
17. Aux Post/Pre Select
18. Aux Send 3&4
19. Aux Post/Pre
Select
16
17
18
19
20