Speck Electronics LiLo - Manual (Page 28)

Chapter 3 Operation Section 24
Group Section
There are two group master sections on the LiLo
mixer. Each section includes a Group Master level
that controls a balanced XLR output on the rear panel.
Each group section also includes a Pan control, Mix
Assign that in conjunction with the pan control assigns
the group mix to the main left/right mix, and In-place
Solo.
This control is the master to the group output
on the rear panel. The VU meters will display
any adjustment to the Group Master controls
when the meter select switch is selected to the
GRP 1-2 position.
This center detent pan control places the group
master anywhere in the stereo left/right mix
when the Mix Assign is enabled.
This switch, in conjunction with the Pan
control, assigns the group mix to the main
left/right mix.
Depressing this In-place solo switch allows you to
isolate the groups panned signal to the monitor outputs
while maintaining stereo perspective.
When a group Mix Assign switch is depressed, this
dual color LED will illuminate either green or red
depending on the combination of switches that are
assigned on any input channel. The reason for this
display is to alert the user that a common signal from
any input channel has been assigned to both the Mix
and Group. Only when the group mix switch [41] is
assigned is this LED relevant.
39. Group Master Level
40. Pan Control
41. Group Mix Assign
42. Solo
43. Mix Assign
LED Display
Logic Truth Table
Group Mix Assign б в в в в
Channel Mix assign X б в в в
Channel Group 1 Assign X в б в в
Channel GRP Select X б б в б
LED color Off G G G R
Figure 11. Mix assign LED truth table
39
42
41
43
40
G=Green, R=Red, X=Irrelevant, â=Switch Down, á=Switch Up
[41]
[10]
[11]
[12]
[43]