Speck Electronics LiLo - Manual (Page 25)

Chapter 3 Operation Section 21
This 100mm dual slider is the master volume to the
transformer balanced mix outputs. The VU meters will
display any adjustment to this Stereo Master control
when the Meter Select switch is set to the "Mix L-R"
position.
Under normal operating conditions the fader should
always be set at maximum. If it has to be pulled down
a significant distance it indicates that the levels at the
input channels are too high and should be reduced.
Four momentary pushbutton switches select the source
to the Monitor Master control. Each switch has a red
LED.
The source for the monitor can be:
Mix- This is the stereo mix of the LiLo post the
stereo master fader
DAW- This is any mono/or stereo signal that is
connected to the DAW return.
Mix+DAW - When pressed, any signal from the
DAW return is combined with the overall mix,
post the stereo fader.
2T - This is any mono/or stereo signal that
is connected to the 2 Track return.
This adjusts the overall level to the stereo
monitor outputs on the rear panel. The Monitor
Master typically controls the volume to a
stereo power amplifier or powered speakers.
When depressed, this switch sums the left and
right signal together, creating a mono
composite for the monitor mix. The operation
of the Mono switch does not affect the main
stereo mix.
The Mono switch allows the user to check for
any out-of-phase signals or simply monitoring your
mix in monaural.
25. Stereo Master
26. Monitor
Source Select
27. Monitor Master
28. Mono Select
Master Module
27
26
25
28