Spectrum Controls 1762sc-IF4OF4 - Manual (Page 25)

Chapter 3: Configuring the 1762sc-IF4OF4 for RSLogix 500 3-3
User’s Manual Pub. 0300247-01 Rev. C
5.) Repeat steps 1 through 4 for additional modules.
Section 3.4
Module
Configuration
The IF4OF4 is configured using the output data table within RSLogix 500.
3.4.1 Output Data File (Configuration Data)
The output data file is used to configure the advanced settings of the module including
input type, output type, data format, filter settings, etc. Use the addressing scheme below
to locate the 8 output words needed to configure the module.
(1) I /O located on the controller (embedded I/O) is slot 0. I/O added to the controller (expansion I/O) begins
with slot 1.
The table below shows the general layout for the 8 output words used for configuration.
Table 3-1 (Output File)
Register Function
Output File (Used for Module Configuration)
O:e.0
Channel 0 Data Word
O:e.1 Channel 1 Data Word
O:e.2 Channel 2 Data Word
O:e.3 Channel 3 Data Word
O:e.4 Low byte: Channel 0 Configuration Register (Output) 1