Spectrum Controls 1762sc-IF4OF4 - Manual (Page 27)

Chapter 3: Configuring the 1762sc-IF4OF4 for RSLogix 500 3-5
User’s Manual Pub. 0300247-01 Rev. C
Output
Range Output Value Condition Raw/Prop EU PID % FS
-10.00 V dc Low Range -29788 -10000 0 -10000
-11.00 V dc Low Limit -32768 -11000 -819 -11000
0 to 5V
5.50 V dc High Limit 32767 5500 18021 11000
5.00 V dc High Range 26809 5000 16383 10000
0.00 V dc Low Range -32768 0 0 0
0.00 V dc Low Limit -32768 0 0 0
0 to 10V
11.00 V dc High Limit 32767 11000 18021 11000
10.00 V dc High Range 26809 10000 16383 10000
0.00 V dc Low Range -32768 0 0 0
0.00 V dc Low Limit -32768 0 0 0
1 to 5V
5.50 V dc High Limit 32767 5500 18431 11250
5.00 V dc High Range 26809 5000 16383 10000
1.00 V dc Low Range -20853 1000 0 0
0.00 V dc Low Limit -32768 000 -4096 -2500
3.4.3 Input Channel Configuration (Channels 4 and 5)
Channels 4 and 5 are current only channels. The table below describes the configuration
options for channels 4 and 5.
Table 3-4 (Configuration for Input Channels 4 and 5)
To Select Make these bit settings
7 6 5 4 3 2 1 0
Filter Frequency
(Ignored if Display
CJC)
17 Hz 0 0
4 Hz 0 1
62 Hz 1 0
470 Hz 1 1
Data Format
Engineering Units X1 0 0
Engineering Units X10 0 1
Raw/Proportional Data 1 0
Scaled for PID 1 1
Input Type
4 to 20 mA 0 0
0 to 20 mA 0 1
Reserved 1 0
Channel Disabled 1 1
Open Circuit
(For Module) 4
Upscale 0
Zero 1
Temperature Scale
(For Module) 4
Deg C
0
Deg F 1
4
This is a module wide setting which is only recognized within the configuration for Channel 4. The
corresponding bit in Channel 5 is ignored.