SurgeX SU-1000Li - Manual (Page 4)

SU1000Li Manual
3
USB Communications Port Connection (optional)
The Power Monitoring Software can be used with the UPS. Use the interface cable that comes with the UPS.
Connect one end of the USB cable to the USB communications port on the rear panel of the UPS. Connect the
other end of the USB cable to the device that will be monitoring/controlling the UPS. NOTE: Connecting to the
communications port is optional. The UPS works properly without this connection.
Phone/Fax/Modem/Network Protection Connection (optional)
Connect a 10/100 Base-T network, single line phone, fax or modem line to the RJ-11/45 modular connectors on
the rear panel of the UPS. This connection will require another length of telephone (provided) or network cable.
The cable coming from the telephone service or network system is connected to the port marked “IN”. The
equipment to be protected is connected to the port marked “OUT”. NOTE: Connection to the
phone/fax/modem/network modular connectors is optional. The UPS work properly without this connection.
OPERATION
Charging The Battery
The UPS will charge the internal batteries whenever the UPS is connected to an AC source and there is an
acceptable AC voltage present (90-150VAC). It is recommended that the UPS’s batteries be charged for a
minimum of 4 hours before use. The UPS may be used immediately; however, the “On Battery” runtime may be
less than normally expected. NOTE: If the UPS is going to be out of service or stored for a prolonged period of
time, the batteries must be recharged for at least 25 hours every ninety days.
Turning The Unit On/Off
Press and release the small black On/Off button on the front panel to turn the UPS on. The alarm will sound on
beep and the LED’s will cycle while the UPS performs a five second internal self-test. Once the UPS has passed
its internal self-test the UPS will provide an output and the load will be powered. Press and release the On/Off
button to turn the UPS off. The UPS will continue to charge the batteries whenever it is plugged into a wall
outlet and there is an acceptable AC voltage is present.
USB Communications Port
The USB communications protocol is HID. The HID USB driver comes standard in the Windows OS. Simply
plug the USB cable into the UPS and the computer, then follow the prompts on the screen.
Power Monitoring Software
The UPS comes with power monitoring software. See the software CD for the installation of the power
monitoring software.