Taser X2 - Manual (Page 11)

11 Chapter 3 Features
NOTE: X2 battery packs will not work with the X3® or X26™ CEWs, and battery packs designed for the X3 or X26
CEWs will not work with the X2 CEW.
Do not store the PPM anywhere that the gold contacts on the top of the PPM may touch metal objects. If you
cause an electrical short between these contacts, the short will drain the lithium energy cells and may cause the
pack itself to become dangerously hot.
The PPM battery has enough power for approximately 500 5-second discharges depending on temperature,
environment, use of the flashlight, and other factors. The PPM battery will deplete faster in colder weather than
warm weather. Likewise, the battery will deplete faster with the flashlight active.
For more information on installing the PPM, see the Changing the PPM section in this manual.
NOTE: Other battery pack options are available for the X2 CEW. See the Tactical Performance Power Magazine
(TPPM) Battery Pack and Automatic Shut-Down Performance Power Magazine (APPM) Battery Pack sections in
this manual.
Changing the PPM (or Other Battery Pack)
1 Point the CEW in a safe direction.
2 Shift the safety switch to the down (SAFE) position.
3 Remove the Smart cartridges. See the Unloading section in this manual for more information.
4 To unload the PPM, depress the PPM release button and remove the PPM from the handle of the CEW.
Release Button
5 Inspect the battery contacts. Ensure that they appear in working order and are free from dirt or other residue
that may interrupt the battery connection to the CEW.
6 Install the new PPM and ensure that it is fully inserted into the X2 CEW. Apply sufficient force to ensure the
PPM is fully seated. When the PPM battery pack seats properly, the PPM release button should pop out from
the recessed position with an audible click.