Taser X2 - Manual (Page 20)

20 Chapter 3 Features
Selector Switch
With the safety switch in the down (SAFE) position, press the selector switch on the top of the X2 CEW to
configure the system. See the Configuring the X2 CEW and Viewing the System Status section in this manual for
more information.
The selector switch is slightly recessed to ensure that it is not pressed unintentionally during normal operations.
Pressing the selector switch when the safety is in the up (ARMED) position puts the X2 CEW in stealth mode—the
flashlight and LASER are turned off and the CID will dim. Pressing and holding the switch a second time will turn
on the flashlight and LASER.
NOTE: The stealth mode cannot activate features that were turned off during CEW configuration. If the X2 CEW
is configured to not use its flashlight or LASERs, the stealth mode will not turn them on.
NOTE: Using pens or paper clips to attempt to press the selector switch may damage it. Only use your finger to
press the selector switch.
Trigger Switch
Unlike a firearm trigger, the X2 CEW trigger switch is a momentary electrical switch. The trigger is operational
only when the safety is in the up (ARMED) position. Pulling and releasing the trigger switch will deploy the first
selected cartridge and result in an approximately 5-second discharge cycle unless the safety is shifted to the
down (SAFE) position to discontinue the 5-second cycle. Pulling and holding the trigger switch for more than
5 seconds will result in a continuous discharge until the trigger switch is released or the battery is depleted—
whichever happens first.
An X2 CEW equipped with the APPM battery pack is limited to 5-second discharges and emits an audio alert 2
seconds before the end of the cycle. See the Audio Performance Power Magazine (APPM) Battery Pack section
in this manual for more information.
In the event of an accidental discharge, immediately shift the safety switch to the down (SAFE) position to
stop the discharge cycle.
Trigger Switch