Tiptop Circadian Rhythms - Manual (Page 29)

27
To set up DAW sync using SW Sync, simply set the PPQN value to 24 as shown below. (24 pulses
per quarter note x 4 for a four beat measure = 96th notes).
One last step: set the right sync on the CR. In Vertical mode, hold down the Global button until the
normal Vertical mode disappears. This is Global mode. In the upper righthand corner, you should se-
lect the sync mode that you set up in SW Sync. If you went with 16th note sync, select 16TH. If you
chose DAW mode, press the DAW button to activate it. Press the Vertical button to exit Global mode.
Start the timeline or clock of your DAW (usually this means pressing the Play transport button). If
your connections working properly, you now have rock solid sync!
Reset can be set many different ways based on the needs of the session. When set to ‘Run’ in Silent
Way, the output will remain high until playback is stopped. Change the ‘Run Type’ to ‘Start’ and the
‘Beats’ setting then sends out Reset pulses based on the ‘Divisor’ instead of the static Run signal.
To send a reset every 4 bars, set the ‘Beats’ to 16 and ‘Divisor’ to 1/4 (16 beats / 4 beats per bar =
4 bars).
Silent Way Sync Set for DAW Sync