UVP 81-0333-01 BioLite Xe - Manual (Page 14)

BioLite Xe MultiSpectral Light Source 14
5. Plug the power cable into the receptacle on the back of the BioLite Xe and the other end into a
power outlet.
Return Procedure
A Returned Goods Authorization (RGA) number must be obtained from UVP Customer Service before
returning any product. See “Technical Support” below for contact information.
Replacement Parts and Accessories
To order accessories or replacement parts for the BioLite MultiSpectral Light Source, contact UVP’s offices.
Part Description Part Number
Xenon Lamp Replacement Kit 98-0111-01
Fuses 56-0002-05 (Qty. 2 Required)
370 – 430 nm Filter (for BFP, CFP, Etc.)
38-0319-01
422 – 478 nm Filter (for GFP, Cy2, Etc.) 38-0319-02
500 – 680 nm Filter (for Cy 5.5) 38-0319-07
Blue Filter (to enhance red and yellow objects)
38-0319-03
Red Filter (darkens green and blue objects) 38-0319-04
Green Filter (increases for red or blue objects) 38-0319-05
Yellow Filter (safelight for photo resist materials) 38-0319-06
Other standard and custom filters are available for a variety of imaging applications. Contact UVP
or visit www.uvp.com for further information.
Troubleshooting
Bulb Does Not Illuminate
1. Recheck the main power cord connection to the BioLite unit.
2. Check the fuses located at the back of the unit next to the power port. A small flat-head screwdriver
or similar tool will be required. Turn the fuseholder cap counterclockwise and the fuse holder will
pop out. Inspect the thin wire within the glass fuse to see if there is a break in the wire. If so,
replace the fuse(s). If fuses are blowing repeatedly, contact UVP Technical Support for additional
troubleshooting.
3. The bulb’s wires may have come loose. Recheck the bulb electrical connections by following the
“Bulb Replacement” instruction earlier in this manual.
4. The bulb may be burned out. Follow the “Bulb Replacement” instruction earlier in this manual.
.
Care and Cleaning
Use only mild soap or detergent solution for cleaning. Do NOT use oil- or petroleum-based cleaners for the
cabinet. Ensure that the system is turned OFF and unplugged during cleaning.