UVP 81-0333-01 BioLite Xe - Manual (Page 7)

BioLite Xe MultiSpectral Light Source 7
Epi Light Guide Installation (BioSpectrum
®
)
1. Remove the epi light covers at the top of the darkroom.
2. Remove one stopper at the left side of the darkroom.
3. Thread the knurled (non-smooth side) of the fiber optic cable from the inside of the darkroom
through the hole created by removing the stopper until the large bulb separating the smooth and
rough side of the fiber optic cable can no longer be pushed through the opening.
4. The light guides should be on the inside of the darkroom. Make sure the fiber optic cables extend
from the light guide toward the front of the darkroom (toward you). Match the drilled holes in the
light guide holders to the protruding screws on the epi light structure. Use the brass thumb nuts to
secure the light guides to the darkroom.
5. Remove the rubber cap from the input side of the fiber optic trunk and plug the cable into the left
port on the BioLite unit.
Epi Light Guides
Stopper
Fiber Optic Cable
Attach light guides to these
screws at top of darkroom
using the brass thumb nuts
Plug the Fiber
Optic Cable into
the left port