UVP 81-0333-01 BioLite Xe - Manual (Page 6)

BioLite Xe MultiSpectral Light Source 6
Setup Instructions
BioLite MultiSpectral Light Source Setup
1. Plug the power cord into the receptacle on the back of the unit and the other end to a power outlet.
Connect the USB cable to the BioLite and the other end to an available port on the computer.
2. Position the BioLite to the left of the darkroom.
Excitation Filter Installation
Filters are installed in a metal black casing from the UVP factory. To install the filters into the BioLite filter
wheel:
1. Hold the filter assembly so that it is positioned vertically with the filter holder’s ridge facing toward
the front of the BioLite as shown below.
2. Slide the filter into the filter wheel as shown below. The small metal tab on the filter holder will
magnetically hold the filter in place within the BioLite. Note: Do not force the filter into the BioLite
wheel slot. If the filter is not fitting smoothly, ensure that the orientation of the filter assembly is
correct.
3. To access the other filter positions, manually rotate the filter wheel with the BioLite powered off.
USB Cable
Power Cord
Ridge
Side of
BioLite