VAC Phi "Kappa 30i" User Manual
Page 11
10
INSTALLATION
1)
Provide adequate ventilation.
2)
Do not operate on carpet or any other surface that might block air flow.
3)
The chassis will become warm in normal use.
4)
Do not allow the chassis to touch any metal parts, such as the frame of an equipment
rack. This might create a parallel ground path that could degrade the sound of your
system.
5)
Input connection is via single ended RCA jacks or XLR jacks (which can be from
balanced or unbalanced sources). Output can be on RCA or XLR (balanced only)
jacks. Connect line level inputs (CD, Tuner, Tape, etc.) to the appropriate RCA input
jacks on the rear panel. Note: with the exception of Phono (when fitted), all inputs
are "line level"
6)
Connect phono cables to the rear panel MM and/or MC inputs labeled "Phono"
(both may be used in the same system, as they are switched by a control on the
front panel). Connect the ground wire(s) from the turntable(s) or phono cable(s) to
the "Ground" terminal provided on the rear panel.
7)
Set the Power Amplifier input switch
(rear panel) to “Preamp” for normal
operation.
If you are biamplifying with an active
crossove, see the “Power Amp Direct
Input” section later in the manual.
8)
Connect the power cables from the power supply to the audio chassis. Be sure to
insert the connector properly, and fully tighten the locking screws.