VAC Phi "Kappa 30i" User Manual
Page 12
11
9)
Connect the speaker cables and set the impedance selector switch to match the
nominal or minimum impedance of your loudspeakers (you may try both).
10)
Connect the power supply to the power source indicated on the rear panel, either
100, 120, 220, or 240 volts AC. The voltage may be select by means of the
removable selector card located underneath the fuse in the power connector; to
change, remove the card and reinstall so that the desired voltage may be read.
Avoid power conditioners that float the ground pin. ALWAYS connect power cord
to component before plugging it into an AC outlet, and make sure that unit's power
switch is set to the "off" position before making the final connection. For best
performance, try to route the power cord away from signal cables.
11)
Pay close attention to power quality, and be aware that different power cords can
alter the sound. The backlit meter shows variation in power line voltage as reflected
to the audio circuitry.