VAC Phi "Kappa 30i" - Manual (Page 9)

8
Set the beveled glass top into the aluminum
top frame. Take care not to chip the edges.
Note: The top glass will become hot in normal
operation.
The glass may be removed from the Phi Kappa (such as for replacement or for shipment)
by following these steps in reverse order.
When loosening the metal and nylon setscrews, be careful not to back them all of the way
out of the holes! If a metal screw falls into the amplifier, contact VAC for service directions.
Connect the DC cables from the power
supply.
Turn the locking collars fully tight (many turns
required!).
NOTE: Do not plug the power supply
into the wall outlet unless it is
connected to the audio chassis.
Connect the iVAC data communications cable
to an associated Phi Power Amplifier if
appropriate. This allows the preamplifier to
control power on, power off, and logo
illumination intensity.
Alternatively, the 12 volt trigger outputs may
be used to switch on/off some brands of
power amplifiers.