VAC Phi "Kappa 30i" - Manual (Page 6)

5
From each of the columns remove the tape, which prevented the nylon setscrews from
coming loose during shipment.
Slide the side glass plates into the pillars’
channels.
The glass will not go all the way to the chassis
top, but has a gap at the bottom for air flow.
Take care not to scratch or break the glass
Note: tubes should not be installed yet.
The front glass has the etched VAC logo. Install
this between the front pillars. Take great care
not to scratch this glass.
The front glass fits into a small channel in the
front plate.
Tighten the white nylon setscrews that secure
the side glasses. Turn clockwise to tighten.
There are four setscrews for each glass plate.
Do not tighten the setscrews for the front glass
yet.