Maintenance kit instructions, Warning – Weston Pro 1100 Vacuum Sealer User Manual
Page 14
-13-
Some parts of the
Vacuum Sealer may need replacing after repeated use. The Vacuum
Sealer Maintenance Kit will be necessary for the Vacuum Sealer to properly function.
REPLACING THE OVAL VACUUM CHAMBER SEALS:
1. Turn “OFF” the
Vacuum Sealer and remove the Power Cord from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the
Vacuum Lid.
4. Remove the
Oval Vacuum Chamber Seal from the groove on the underside of the
Vacuum Lid.
5. Remove the
Oval Vacuum Chamber Seal from the groove in the Plastic Vacuum
Chamber.
6. Set a new
Oval Vacuum Chamber Seal on the groove in the Plastic Vacuum
Chamber. Work the seal into the groove with your fingers until done.
7. Position a new
Oval Vacuum Chamber Seal into the groove in the Vacuum Lid.
Work the seal into the groove with your fingers until done.
REPLACING THE SEAL BAR TAPE:
1. Turn “OFF” the
Vacuum Sealer and remove the Power Cord from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the
Vacuum Lid.
4. Pick at either end of the
Seal Bar Tape covering the Seal Bar Heating
Element with a fingernail until it lifts slightly. Grasp the loose end and slowly pull
the
Seal Bar Tape back over itself until fully removed.
5. Remove the backing from a new strip of
Seal Bar Tape. Be careful not to allow the
Seal Bar Tape to contact anything including itself while the adhesive side is exposed.
6. Hold one end of the
Seal Bar Tape in each hand. Stick the left end of the Seal Bar
Tape to the flat area on the Plastic Vacuum Chamber just left of the Seal Bar Heating
Element. Apply the Seal Bar Tape from left to right over the Seal Bar Heating Element
until done. Make sure there are no wrinkles or folds in the
Seal Bar Tape once applied.
The
Seal Bar Tape should fully cover the Seal Bar Heating Element.
MAINTENANCE KIT INSTRUCTIONS
WARNING!
Before cleaning, assembling or disassembling the Vacuum Sealer,
make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED FROM THE
OUTLET/POWER SOURCE!