Weston Pro 1100 Vacuum Sealer - Manual (Page 17)

-16-
REPLACING THE FUSE
If the Vacuum Sealer does not operate when it is plugged in and
turned on, try any or all of the following:
1. Make sure the
Fuse is not blown. The Fuse is located on the right
side of the unit directly above the Power Cord Port. Turn “OFF” and
unplug the Vacuum Sealer. Twist off and remove the Fuse Holder.
Remove and check the Fuse. The thin metal band in the center of
the Fuse should be clean and unbroken. If it is burned and/or broken,
replace it with a new Fuse (8 Amp). Replace the Fuse Holder.
2. Make sure the Connector at the end of the Power Cord is
plugged completely into the Power Cord Port.
3. Make sure the Power Cord is not damaged. DO NOT use
a damaged Power Cord. Call the Customer Service line for
information on part replacement.
4. Try connecting the Power Cord Plug to another electrical outlet.
WARNING!
Before cleaning, assembling or disassembling the Vacuum Sealer,
make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED FROM THE
OUTLET/POWER SOURCE!
I O
Figure 13