Xblue Networks X16 - Manual (Page 33)

Issue 2 -
33 -
Fea
tu
re
s
Flash
The flash command ( Feature +  ) is used to invoke features on telephone lines
such as call waiting and three-way calling. The Flash command may be
programmed on one of the programmable buttons.
Flash Timer
This adjustable timer is used to compensate for telephone network variations.
Forward
Calls can be forwarded to one of three destinations; voice mail, external number
or trunk to trunk. Calls transferred to an extension that is forwarded, will only
forward after the “Waiting Time ” has expired. At default the Waiting Time is set
to 10 seconds. Use the “Programming” area to program this parameter.
Voice mail – When an extension is forwarded to voice mail, the center navigation
button will illuminate (lit solid); no other visual indication will be given. After the
expiration of the Waiting Time, the call will be diverted (redirected) to the
extension‟s voice mail greeting.
TRK2TRK – When an extension is forwarded to an external number the system
will send a command to the telephone network line, known as a “Flash”, which
begins the transfer. The telephone system will then dial the preprogrammed
digits, pause until the call is established, and then hang up, releasing the call
from the system. TRK2TRK FWD will appear in the display, use the right
navigation button to clear this from the display.
Note:
This feature may require a special service from the telephone company central office
called, “Three-way calling with call disconnect”. Please consult with your telephone
company for information regarding this feature. This type of forwarding may result in a
usage and toll charge for each forwarded call . Any and all toll charges are the sole
responsibility of the user of the installed equipment; XBLUE offers no warranty or will
assume any responsibility for any toll charges.
External – External Call forwarding uses two telephone system lines.
1) This feature occupies two CO Lines. Therefore, if a second CO Line
is not available, the call will not forward. Also, a slight volume
decrease is normal.
2) If an ancillary device (single line before the system) is on a CO Line,
and the system does not detect that line as being busy, the system
will forward the call, and dial over the call.