Xblue Networks X16 - Manual (Page 35)

Issue 2 -
35 -
Fea
tu
re
s
that headset can be enabled and disabled as needed. In addition, a headset
must be plugged in to enable or disable the headset mode.
Note: The voice quality and performance of headsets may vary .
Hold
Extension users may place Telephone Company central office line calls on hold
allowing them to be picked up at other extensions.
Hot Dial Pad
Hot dial pad allows extension users to dial numbers without lifting the handset or
pressing the speaker button.
Intercom Calling
Each extension is assigned a unique three digit code (number) ranging from 301
to 399. The number used at the time of registration and becomes that
extension‟s intercom number. Dial the three digit code to intercom another
extension. DSS/BLF buttons allows for one touch intercom calling.
Intercom Paging
Intercom paging is similar to intercom calling, but when the call is connected, the
called party‟s mute button is active. This allows the called party to have private
conversations without being overheard.
Line Status Detection (Line in Use)
From Idle to Busy – The system will detect if another device is using one of the
telephone Lines and will automatically identify the line as busy.
From Busy to Idle – The system will detect when the line is no longer busy, and
automatically identify the line as idle.
Not Connected – If a telephone line is not connected to the system, it will be
automatically disabled, and no one will be able to connect to the line. A beep
tone is heard if a disabled telephone Line is pressed.
Non-system phone picking up the call – When the call is picked up by a non-
system phone, the system will, after 2 seconds, light the line button and show
that the line as busy. However, one digital telephone may join in on the call by
pressing the lit CO Line. If a second digital telephone tries to join the
conversation both digital telephones will be disconnected but the non-system