Returning to factory defaults, Saving setup options – Fluke 189 User Manual
Page 78
Model 187 & 189
Users Manual
5-8
Returning to Factory Defaults
Your meter comes with the setup options preset at the
factory. These factory settings are shown in Tables 5-1
and 5-2. You can always return to these settings as
follows:
1. Press
O
T
until
Fcty
appears in the display.
2. Press
%
to select
yE5
; press
T
to select
no
.
If you select
yE5
, all setup options revert to the
factory defaults; you cannot specify individual
choices.
3. Press
O
T
to exit the setup procedure and
activate your selection.
If you selected
yE5
in step 2, all factory settings are
restored.
If you selected
no
, selections made in the Setup
mode become active.
Saving Setup Options
At each setup option, store your choice and advance to
the next option by pressing
O
T
.
If you are storing the last option, this also exits the setup
mode.
To exit the Setup mode without saving the present option,
press
O
N
(CANCEL).
Selections that were previously saved with
O
T
are
retained.