Dukane 8755G-RJ - Manual (Page 69)

3
Network Functions
Before Using the Network Functions…
To use the network functions of this projector, the projector must be configured to
suit your network. Consult with your network administrator before connecting the
projector to your network. Incorrect network configuration of this projector may
cause problems on your network.
Connect the gateway (The router/PC that forwards traffic to a destination outside
of the subnet of the transmitting device) to the LAN port on the projector using a
CAT-5 cable and configure the following settings.
If using a network with DHCP enabled:
The projector’s network settings can be configured automatically when DHCP on
the NETWORK menu is set to ON. Please refer to DHCP and INFORMATION in
NETWORK menu ("NETWORK menu" section of the User's Manual - Operating Guide).
If a fixed / static IP address is required, please configure your projector according
to the steps in the following section.
If using a network without DHCP enabled
or using a fixed IP address on a network with DHCP enabled:
Configure the following settings on the NETWORK menu ("NETWORK menu"
section of the User's Manual - Operating Guide).
. DHCP : Set DHCP to OFF (disabled).
. IP ADDRESS : Enter an appropriate IP address for the projector to connect to
your network.
3. SUBNET MASK : Enter an appropriate subnet mask for the projector to
connect to your network.
4. DEFAULT GATEWAY : Enter an appropriate gateway address for the
projector to connect to your network.