Mini mobility system – Mini 2008 Cooper Convertible User Manual

Page 145

Advertising
background image

143

OVER

VIEW

RE

P

A

IR

S

OP

ERATI

O

N

C

ONTR

OLS

DA

T

A

IN

DEX

MINI MOBILITY SYSTEM

*

If an air pressure of 26 psi/180 kPa
cannot be reached, unscrew the

hose 1 and drive back and forth
about 33 ft/10 m so that the liquid seal-
ant is distributed in the tire. Afterwards
repeat the procedure.
If an air pressure of 26 psi/180 kPa is still
not reached, the tire is too badly dam-
aged. Please contact the nearest MINI
Dealer.

<

5. Turn off compressor 2
6. Unscrew hose 1 from the tire valve
7. Store the MINI Mobility System back in

the vehicle.

The instructions for using the MINI
Mobility System are also given on the

equipment.

<

Distributing liquid sealant

Immediately drive for approx. 10 minutes,
so that the liquid sealant is uniformly dis-
tributed.

Do not exceed a speed of 40 mph /
60 km/h.

If possible do not drive at a speed lower
than 10 mph / 20 km/h.

<

Checking tire inflation pressure

1. After driving for approx. 10 minutes, pull

over at a suitable location

2. Screw hose with manometer back onto

the tire valve

3. Check the tire inflation pressures.

The tire inflation pressure must be
at least 18 psi/130 kPa. If it is not,

do not continue driving.

<

If 18 psi/130 kPa are displayed:

4. Ignition key position 1:

switch on compressor 2. Correct the tire
inflation pressure to the specified value,
refer to the tire inflation pressure table
on page

109

5. Replace the tire as soon as possible.

The use of the MINI Mobility System
may be ineffective with tire damage

larger than approx. 1/6 in/4 mm. Please
contact the nearest MINI Dealer if the tire
cannot be made drivable with the MINI
Mobility System.

<

Driving on

Do not exceed the permitted maxi-
mum speed of 50 mph / 80 km/h;

otherwise an accident could happen.

<

Replace the defective tire as soon as
possible and have the new wheel/tire

assembly balanced. Have the MINI Mobility
System refilled.

<

Tire change set

When changing a tire, always observe the
safety measures and the procedure for
changing tires starting on page

137

.

In case of a flat tire the tire change
set is not needed due to the availabil-

ity of the MINI Mobility System.

<

Online Edition for Part no. 01 41 0 014 845 - © 08/07 BMW AG

Advertising
This manual is related to the following products: