Altera Audio Video Development Kit, Stratix IV GX Edition - Manual (Page 55)

Appendix A: Programming the Flash Memory Device A–5
Restoring the MAX II CPLD to the Factory Settings
© November 2009 Altera Corporation Audio Video Development Kit, Stratix IV GX Edition User Guide
nios2-terminal
r
and follow the instructions in the terminal window to generate a unique MAC
address.
f To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Altera Development Kits page of the Altera website.
Restoring the MAX II CPLD to the Factory Settings
This section describes how to restore the original factory contents to the MAX II CPLD
on the development board. Make sure you have the Nios II EDS installed, and
perform the following instructions:
1. Set the board switches to the factory default settings described in “Factory Default
Switch Settings” on page 4–2 .
1 Setting DIP switch SW6.1 to the off position includes the MAX II device in
the JTAG chain.
2. Launch the Quartus II Programmer.
3. Click Auto Detect.
4. Click Add File and select <install
dir>\kits\stratixIVGX_4sgx230_av\factory_recovery\max2.pof.
5. Turn on the Program/Configure option for the added file.
6. Click Start to download the selected configuration file to the MAX II CPLD.
Configuration is complete when the progress bar reaches 100%.
f To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Audio Video Development Kit, Stratix IV GX Edition
page of the Altera website.