Altera MAX V CPLD - Manual (Page 9)

January 2011 Altera Corporation MAX V CPLD Development Kit User Guide
2. Getting Started
The remaining chapters in this user guide lead you through the following MAX V
CPLD development board setup steps:
■ Inspecting the contents of the kit
■ Installing the design and kit software
■ Setting up, powering up, and verifying correct operation of the CPLD
development board
■ Running the Board Test System designs
f
For complete information about the CPLD development board, refer to the
MAX V CPLD Development Board Reference Manual .
Before You Begin
Before using the kit or installing the software, check the kit contents and inspect the
board to verify that you received all of the items listed in
“Kit Features” on page 1–1 .
If any of the items are missing, contact Altera before you proceed.
Inspect the Board
To inspect the board, perform the following steps:
1. Place the board on an anti-static surface and inspect it to ensure that it has not been
damaged during shipment.
c Without proper anti-static handling, you can damage the board.
2. Verify that all components are on the board and appear intact.
1 The SPI EEPROM (U8) and the I 2 C EEPROM (U6) are not included with the
MAX V CPLD Development Kit.
References
Use the following links to check the Altera website for other related information:
■ For the latest board design files and reference designs, refer to the MAX V CPLD
Development Kit page.
■ For the MAX V device documentation, refer to the Literature: MAX V Devices
page.
■ To purchase devices from the eStore, refer to the Devices page.
■ For MAX V OrCAD symbols, refer to the Capture CIS Symbols page.